ASDA-M Chapter 8 Parameters
Revision December, 2014 8-65
Settings：
If the setting is wrong, the servo motor will easily have sudden
unintended acceleration.
Please follow the rules for setting:
The setting of pulse input:
Range of command pulse input : 1／50＜Nx／M＜25600
NOTE
1) The setting value cannot be changed when Servo ON neither
in PT nor in PR mode.
P1-46▲
GR3 Pulse Number of Encoder Output
Address: 015CH
015DH
Parameter
Attribute：
Parameter for individual axis
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
2500
Control
Mode：
ALL
Unit：
Pulse
Range：
20 ~ 320000
Data Size：
32bit
Format：
DEC
Settings：
The number of pulse output per revolution.
NOTE
The following circumstances might exceed the max. allowable
input pulse frequency and occurs AL018:
1. Abnormal encoder
2. The motor speed is faster than the setting of P1-76.
3.
6
1019.8 4 461P
60
Speed Motor
To Next Page
Loading...
