Delta ASDA-M Series User Manual

Chapter 8 Parameters ASDA-M
8-126 Revision December, 2014
P3-12 QSTPO CANopen Support Setting
Address: 0318H
0319H
Parameter
Attribute：
Parameter for three axes
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
0x0000
Control
Mode：
CANopen
Unit：
-
Range：
Shown as below
Data Size：
16bit
Format：
HEX
Settings：
The supporting setting of CANopen is divided into X, Y, Z and U
(hexadecimal):
Item U Z Y X
Function undefined
CANopen value will be
loaded in
undefined undefined
Range - 0~1 - -
The definition is as the followings:
X, Y, U: undefined
Z=0: After re-power on or reset the communication, CANopen
default value will be loaded in.
Z=1: After re-power on or reset the communication, parameter
value will not be changed.

Delta ASDA-M Series Specifications

General

Brand	Delta
Model	ASDA-M Series
Category	Servo Drives
Language	English