Delta ASDA-M Series User Manual

Chapter 8 Parameters ASDA-M
8-196 Revision December, 2014
Command code 0004h Motion parameter protection: unlock the
protection
Macro parameters P5-96= enter the password (1~16777215)
This function can be executed when activating the function of parameter
protection.
If the protection function is unlocked, repeatly execute this function will sent
back the failure code.
If enter the wrong password, failure code Ennn will be sent back. nnn means
the rest decode number. It will be minused one number after one failure.
When the number is 0, it will be locked for good.
Failure code F041h Protection function is unlocked and it cannot be
repeatly unlocked.
Failure code F043h The password setting exceed the allowable range
(1~16777215).
Failure code F044h The number of times of entering wrong password
exceeds the limit: Lock for good.
Reset the parameter (P2-08=10) to unlock it is
the only method. However, all parameter will
return to the default value.
Failure code Ennnh Incorrect password setting: Failed to unlock.
nnn: the rest decode number. It will be minused
one number after one failure. When the number is
0, it will be locked for good.
Success code: 1004h
P5-98 EVON PR# Triggered by Event Rising-Edge
Address: 05C4H
05C5H
Parameter
Attribute：
Parameter for individual axis
Related Section:-
Operational
Interface：
Panel / Software Communication
Default：
0
Control
Mode：
PR
Unit：
-
Range：
0000 ~ 0xDDDD

Delta ASDA-M Series Specifications

General

Brand	Delta
Model	ASDA-M Series
Category	Servo Drives
Language	English