Delta DTM Series - Definitions of Commonly Used Terms; Restoring Default Settings

Chapter 2: Specifications and System Configuration
DTM temperature controller operating manual
2-12
2.8 Definitions of Commonly Used Terms
Abbreviation
Definition
PV Present Value
SV Setpoint Value
OUT Output
ALM Alarm
ALM-H
ALM-L
Alarm High
Alarm Low
CT Current Transformer
TC Thermocouple
RTD Resistance Temperature Detector
2.9 Restoring Default Settings
The DTMs default setting values can be restored using the following steps:
Write the value [H1234] to address [Hx25C], and write the value [H1357] to address [Hx25A], turn off
power, and turn on power again.
 Notes: x indicates the internal station number of the host or measurement expansion module.