Chapter 7: Appendix
DTM temperature controller operating manual
7.1.5 Programmable Control Planning Table Parameter Settings
Name Description CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
Unit: sec Hx2B0 Hx2B1 Hx2B2 Hx2B3 Hx2B4 Hx2B5 Hx2B6 Hx2B7
Unit: min Hx2B8 Hx2B9 Hx2BA Hx2BB Hx2BC Hx2BD Hx2BE Hx2BF
Pattern status
0 ~ 7 Hx290 Hx291 Hx292 Hx293 Hx294 Hx295 Hx296 Hx297
Step status
0 ~ 7 Hx298 Hx299 Hx29A Hx29B Hx29C Hx29D Hx29E Hx29F
Wait SV
Hx400 Hx401 Hx402 Hx403 Hx404 Hx405 H406 Hx407
Number of
remaining rounds
(R) Hx2A0 Hx2A1 Hx2A2 Hx2A3 Hx2A4 Hx2A5 Hx2A6 Hx2A7
Current status of
program (R) Hx2A8 Hx2A9 Hx2AA Hx2AB Hx2AC Hx2AD Hx2AE Hx2AF
Wait time
Hx408 Hx409 Hx40A Hx40B Hx40C Hx40D H40E Hx40F
Start slope
Hx410 Hx411 Hx412 Hx413 Hx414 Hx415 H416 Hx417
Start pattern
0 ~ 7 Hx418 Hx419 Hx41A Hx41B Hx41C Hx41D Hx41E Hx41F
Start step
0 ~ 7 Hx420 Hx421 Hx422 Hx423 Hx424 Hx425 Hx426 Hx427
End step
，
this pattern is executed
Hx428 Hx429 Hx42A Hx42B Hx42C Hx42D Hx42E Hx42F
Cycle count
0 ~ 199, indicates that this
pattern is executed 1~200
Hx430 Hx431 Hx432 Hx433 Hx434 Hx435 Hx436 Hx437
Linked pattern
0 ~ 8, 8 indicates the end
of the program, 0 ~ 7
indicates the next pattern
number to be executed
Hx438 Hx439 Hx43A Hx43B Hx43C Hx43D Hx43E Hx43F
Step0 setting
Step1 setting
Step2 setting
Step3 setting
Step4 setting
Step5 setting
Step6 setting
Step7 setting
To Next Page
Loading...
