Chapter 7: Appendix
DTM temperature controller operating manual
7.3 Ethernet/ IP Software Setting
This chapter describes how to set up DTME series models through Delta communication
software DCISoft, and explains the fields on each setting page. Before opening the setting
page, DCISoft must first select Ethernet in the communication settings. After the setting is
complete, you can open the DTME series model setting page through broadcast search and
specified IP search. The setting function of DTME series models is to use UDP port 20006.
Please pay attention to the relevant settings of the firewall. The following details explain how
to open the settings page and the functions of each field.
Set the connection method as shown in the figure below. The computer can be connected to
the DTME series models via a HUB connection or directly using a network cable.
7.3.1 Setting up Communication and Searching for Modules in DCISoft
Communication Setting
1. Open DCISoft on the PC and select “Tools” => “Communication Setting”.
To Next Page
Loading...
