Chapter 7: Appendix
DTM temperature controller operating manual
Chapter 7
Appendix
7.1 RS485 & Ethernet Communications
7.1.1 Comm. commands for DTM Host and Measurement Expansion Module
1. Before turning on power to the DTM host, first set dip switches, station number addresses, and all
attribute expansion module station number addresses.
2. Function code (Function): H03 = read the register content, up to 64 words; H06 = write a word to the
register; H10 = write multiple words to the register, up to 64 words.
See the table below for communications function addresses and their content: (x represents the internal
station number, x=0 indicates the DTM host)
Hx000 Hx001 Hx002 Hx003 Hx004 Hx005 Hx006 Hx007
limit
limit~
Hx008 Hx009 Hx00A Hx00B Hx00C Hx00D Hx00E Hx00F
SV low limit
limit~ SV high
Hx010 Hx011 Hx012 Hx013 Hx014 Hx015 Hx016 Hx017
Input Offset
Hx018 Hx019 Hx01A Hx01B Hx01C Hx01D Hx01E Hx01F
Input Gain
Hx020 Hx021 Hx022 Hx023 Hx024 Hx025 Hx026 Hx027
Corresponding to
input sensor type
Hx028 Hx029 Hx02A Hx02B Hx02C Hx02D Hx02E Hx02F
filtering
range: 0 ~ 50
default:8
Hx030 Hx031 Hx032 Hx033 Hx034 Hx035 Hx036 Hx037
filtering
default:10
Hx038 Hx039 Hx03A Hx03B Hx03C Hx03D Hx03E Hx03F
Hx040 Hx041 Hx042 Hx043 Hx044 Hx045 Hx046 Hx047
ALM1 delay
Hx048 Hx049 Hx04A Hx04B Hx04C Hx04D Hx04E Hx04F
ALM1
option
value
Bit2: hold
Bit1: invert
Hx050 Hx051 Hx052 Hx053 Hx054 Hx055 Hx056 Hx057
Hx058 Hx059 Hx05A Hx05B Hx05C Hx05D Hx05E Hx05F
ALM2 delay
Hx060 Hx061 Hx062 Hx063 Hx064 Hx065 Hx066 Hx067
ALM2
option
value
Bit2: hold
Hx068 Hx069 Hx06A Hx06B Hx06C Hx06D Hx06E Hx06F