Chapter 7:Appendix
DTM temperature controller operating manual
7.3.4 IP Filter
The IP filter is used for restricting the connection of the network in case some uncertain IP will cause
errors. Only the IP set within the allowed range can establish the connection; other IPs will be rejected.
Setting up IP filter
1.
Enable IP Filter:
Check the box to enable IP filter.
2.
Begin IP Address:
The beginning IP addresses that are allowed to establish a connection. Max. 8 IPs are
allowed.
3.
End IP Address:
The ending IP addresses that are allowed to establish a connection. Max. 8 IPs are allowed.
To Next Page
Loading...
