Chapter 6: Operating Instructions for Other Auxiliary
Functions
DTM temperature controller operating manual
6.4.2 Input channel assignment description
After enable the multi-loop control mode, you must first allocate the input channel of measurement
devices corresponding to each output channel of the output expansion module.
The position of the input channel of the measurement host and expansion module is expressed: xy, x=0~F
(internal station number); y=0~7 CH, (0 corresponds to input channel 1, and so on).
The following table uses the station number and channel number of the output expansion module as a
reference, corresponding to the communication address of the measurement devices in the table.
1
2
3
4
5
6
7
8
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 8
CH 9
CH 10
CH 11
CH 12
CH 13
CH 14
CH 15
CH 16
Station no.
9
Station no.
A
Station no.
B
Station no.
C
Station no.
D
Station no.
E
Station no.
F
CH 2
CH 3
CH 4
CH 5
CH 7
CH 8
CH 9
CH 10
CH 12
CH 13
CH 14
CH 15
CH 16
To Next Page
Loading...
