Chapter 6: Operating Instructions for Other Auxiliary
Functions
DTM temperature controller operating manual
6.4.6 Read the auxiliary output percentage of the output channel
In the auto multi-loop control mode, each output channel only needs to be written into the auxiliary SV value. If you
need to confirm the actual output percentage of the output channel, you can read the auxiliary output amount of
each output channel from the address in the following table.
The following table uses the station number and channel number of the output expansion module as a reference,
corresponding to the communication address of the measurement devices in the table.
Channel
1
2
3
4
5
6
7
8
CH 1
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
CH 9
CH 10
CH 11
CH 12
CH 13
CH 14
CH 15
CH 16
Station
Channel
Station no.
9
Station no.
A
Station no.
B
Station no.
C
Station no.
D
Station no.
E
Station no.
F
CH 1
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
CH 9
CH 10
CH 11
CH 12
CH 13
CH 14
x58EH x59EH x5AEH x5BEH x5CEH x5DEH x5EEH
x58FH x59FH x5AFH x5BFH x5CFH x5DFH x5EFH
Note: The CH9~CH16 in the table are applicable to DTM-DOX expansion modules.
To Next Page
Loading...
