Delta DTM Series - Installation Method; Host

Chapter 7:Appendix
DTM temperature controller operating manual
7-14
7.2 Installation Method
7.2.1 Host
Host installation
1) Attach with DIN Rail fastener
2) Hang the DIN Rail fastener at the top of the controller diagonally on the DIN Rail
3) Press down on the DIN Rail fastener at the bottom of the controller to lock it
4) Confirm that the DIN Rail fastener is correctly fastened
Removal from Host
1) Use a flat screwdriver or other tools to insert into the DIN Rail fasteners square hole. Apply
pressure in the direction of the arrow when pulling the DIN Rail fastener out from beneath the
controller
2) Lift up the controller and remove