Chapter 7: Appendix
DTM temperature controller operating manual
7.2.2 Expansion Cassette
Note: When adding/replacing an expansion cassette, make sure power has been shut off to the Host, and
power up the Host after installation. The products in this series do not support hot swapping; please perform
installation only after power has been turned off.
Removal of protective cover
1) Use a flat screwdriver in the gap shown in steps 1-2, and maintain the angle shown in step 3
2)
In step 4, insert straight in the direction and angle shown by the arrow, allowing the protective cover
to be pushed away
3) In step 5, insert a flat screwdriver in the gap in the protective cover, which has already been
pushed off, and lightly pry in the direction of the arrow in step 6, allowing the protective cover to be
removed
To Next Page
Loading...
