Chapter 6: Operating Instructions for Other Auxiliary
Functions
DTM temperature controller operating manual
6.4.5 Auxiliary SV and auxiliary output percentage
In auto multi-loop control mode and manual multi-loop control mode, each output channel of the output
expansion module needs to write the auxiliary SV value and the auxiliary output percentage.
Auxiliary SV value and auxiliary output percentage use the same communication address section, but
they will not be used at the same time due to different setting modes.
The following table uses the station number and channel number of the output expansion module as a
reference, corresponding to the communication address of the measurement devices in the table.
Channel
1
2
3
4
5
6
7
8
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
CH 9
CH 10
CH 11
CH 12
CH 13
CH 14
CH 16
Channel
Station no.
9
Station no.
A
Station no.
B
Station no.
C
Station no.
D
Station no.
E
Station no.
F
CH 1
CH 3
CH 4
CH 5
CH 6
CH 8
CH 9
CH 10
CH 11
CH 13
CH 14
CH 15
CH 16
Notes:
1. The CH9~CH16 in the table are applicable to DTM-DOX expansion modules.
2. Please refer to section 6.4.3 and 6.4.4 for the method of writing and reading the content of communication
addresses.
To Next Page
Loading...
