Delta ME300 Series

Chapter 12 Description of Parameter Settings
ME300
12.1-06-10
50: Emergency stop (EF1)
51: External base block (bb)
52: Password is locked (Pcod)
54: Illegal command (CE1)
55: Illegal data address (CE2)
56: Illegal data value (CE3)
57: Data is written to read-only address (CE4)
58: Modbus transmission time-out (CE10)
63: Over-slip (oSL)
72: S1 internal loop detection error (STL1)
76: STO (STo)
77: S2 internal loop detection error (STL2)
78: S3 internal loop detection error (STL3)
82: Output phase loss U phase (OPL1)
83: Output phase loss V phase (OPL2)
84: Output phase loss W phase (OPL3)
87: Overload protection at low frequency (oL3)
142:
Auto-tuning error 1 (DC test stage) (AUE1)
143:
Auto-tuning error 2 (High frequency test stage) (AUE2)
149: Total resistance measurement fault (AUE5)
150: No-load current IO measurement fault (AUE6)
151: dq axis inductance measurement fault (AUE7)
152: High frequency injection measurement fault (AUE8)
157: Pump PID feedback error (dEv)
 When the fault occurs and forces stopping, the fault is recorded in this parameter.
 During stop with low voltage Lv (LvS warning), there is no error record. During operation with mid-
low voltage Lv (LvA, Lvd, Lvn error), there is a record.
 When dEb function is valid and enabled, the drive executes dEb and records fault code 62 to
Pr.06-17
–Pr.06-22 and Pr.14-70–Pr.14-73 simultaneously.

06-23
Fault Output Option 1

06-24
Fault Output Option 2

06-25
Fault Output Option 3

06-26
Fault Output Option 4
Default: 0
Settings 0–65535 (refer to bit table for fault code)
 Use these parameters with multi-function output terminal (set to 35–38) for the specific
requirement. When the fault occurs, the corresponding terminals activate. Convert the binary
value to decimal value before you enter the value for Pr.06-23–Pr.06-26.