EasyManua.ls Logo

Delta ME300 Series - Page 84

Delta ME300 Series
457 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 7 Optional AccessoriesME300
7-36
Installation
(Frame A model as an example)
1. As shown on the right figures, fix the iron plate on the AC
motor drive.
Torque value:
Frame Screw
Torque
A M3.5 6–8 kg-cm / [5.26.9 lb-in.] / [0.590.78 Nm]
B M4 6–8 kg-cm / [5.26.9 lb-in.] / [0.590.78 Nm]
C M4 6–8 kg-cm / [5.26.9 lb-in.] / [0.590.78 Nm]
D M3 4–6 kg-cm / [3.55.2 lb-in.] / [0.390.59 Nm]
Figure 7-26
2. After selecting a suitable R-clip according to the wire gauge
used, fix the R-clip on the shield plate.
Screw
Torque
M4 6–8 kg-cm / [5.26.9 lb-in.] / [0.590.78 Nm]
Figure 7-27
Table 7-39
Dimensions of EMC Shield Plate
Figure 7-28
Model
Dimensions of Shield Plate
mm [inch]
a b
MKM-EPA 69.3 [2.73] 80.0 [3.15]
MKM-EPB 67.7 [2.67] 79.7 [3.14]
MKM-EPC 78.0 [3.07] 91.0 [3.58]
MKM-EPD 103.4 [4.07] 97.0 [3.82]
Table 7-40
a
b

Table of Contents

Related product manuals