Delta UNISAW User Manual

ASSEMBLY INSTRUCTIONS
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE SAW TO THE POWER
SOURCE UNTIL THE SAW IS COMPLETELY ASSEMBLED AND YOU HAVE READ
AND UNDERSTOOD THE ENTIRE OWNER’S MANUAL.
ASSEMBLING STARTER BOX TO CABINET
If you purchased the machine with magnetic push button electrical controls, the saw is
shipped with the starter box completely wired to the switch and motor. However, the
starter box must be mounted to the saw cabinet. To assemble the starter box (A)
Fig. 7, to the saw cabinet, proceed as follows:
1. From the inside rear of the saw cabinet, insert three 1/4-20 x 1/2" hex head screws
with flat washers and lockwashers into the holes (B) Fig. 7, in the cabinet.
2. Line up the three tapped holes (C) Fig. 7, in the starter box with the screws and
secure the starter box (A), to the saw cabinet.
3. Figure 8 illustrates the starter box (A) assembled to the saw cabinet.
Fig. 8
7

Delta UNISAW Specifications

General

Brand	Delta
Model	UNISAW
Category	Saw
Language	English