Delta UNISAW User Manual

USING AUXILIARY WOOD
FACING ON RIP FENCE
It is necessary when performing special operations such
as moulding to add wood facing (A) Fig. 71, to one or
both sides of the rip fence, as shown. The wood facing is
attached to the fence with wood screws through the
holes provided in the fence. 3/4 inch stock is suitable for
most work although an occasional job may require 1 inch
facing.
A wood facing should be used when ripping thin material
such as paneling to prevent the material from catching
between the bottom of the rip fence and the saw table
surface.
Fig. 71
CONSTRUCTING A PUSH STICK
When ripping work less than 4 inches wide, a push stick should be used to complete the feed and
could easily be made from scrap material by following the pattern shown in Fig. 72.
27

Delta UNISAW Specifications

General

Brand	Delta
Model	UNISAW
Category	Saw
Language	English