Denon AVR-X3000

164
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
2 Front Height
Set the presence and size of the front height speakers.
Large : Use a large speaker that can adequately play back very low
bass frequencies.
Small (Default) : Use a small speaker that has inadequate playback
capacity for very low bass frequencies. Note that this
is almost always the best choice.
None : Select when the front height speakers are not connected.
%
•When “Assign Mode” (vpage162) setting is “Front Height”, you can
make the “Front Height” setting.
2 Front Wide
Set the presence and size of the front wide speakers.
Large : Use a large speaker that can adequately play back very low
bass frequencies.
Small (Default) : Use a small speaker that has inadequate playback
capacity for very low bass frequencies. Note that this
is almost always the best choice.
None : Select when the front height speakers are not connected.
%
•When “Assign Mode” (vpage162) setting is “Front Wide”, you can make
the “Front Wide” setting.
2 Surr.Back
Set the presence, size and number of surround back speakers.
Large : Use a large speaker that can adequately play back very low
bass frequencies.
Small (Default) : Use a small speaker that has inadequate playback
capacity for very low bass frequencies. Note that this
is almost always the best choice.
None : Select when the surround back speakers are not connected.
2spkrs (Default) : Use two surround back speakers.
1spkr : Use only one surround back speaker. When you select this
setting, connect the surround back speaker to the left (L)
channel.
%
•When “Assign Mode” (vpage162) setting is “Surround Back”, you can
make the “Surr. Back” setting.