Denon AVR-X3000

172
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Language
Set the language for display on the menu screen.
English (Default) / Français / Español
%
•“Language” can also be set by the following procedure. However, the menu
screen is not displayed.
Following the display content to make the setting.
1. Press and hold the main unit’s ZONE2 SOURCE and STATUS for at least 3
seconds.
“V.Format:<NTSC>” appears on the display.
2. Press the main unit’s DIMMER.
“Lang.:<ENGLISH >” appears on the display.
3. Use the main unit’s TUNER PRESET CH +, – and set the language.
4. Press the main unit’s STATUS to complete the setting.
General
Make various other settings.
ZONE2 Setup
Set the audio to play back with multi-zone (ZONE2).
%
•The setting values (dB) for “Volume Limit” and “Power On Volume” are what is
displayed when “Scale” (vpage138) in the menu is set to “–79.5dB – 18.0dB”.
2 Bass
Adjust bass tones.
–10dB – +10dB (Default : 0dB)
2 Treble
Adjust treble tones.
–10dB – +10dB (Default : 0dB)
2 High Pass Filter
Make settings for cutting the low range to reduce distortion in the bass.
On : The low range is attenuated.
O (Default) : The low range is not attenuated.