6. Clearing the Operation Info
6.1. Actions
• Displays the accumulated operating time of the unit, the number of times the power was switched on,
and the number of occurrences of each protection.
6.2. Operations
Remove all input/output terminals and the AC plug.
Connect the AC plug again and place the product in standby mode.
While holding down buttons "
OPTION
" and "
DIMMER
" simultaneously, press the power button to turn
on the power.
L1
PRODUCT MODE
Release the buttons when "
PRODUCT MODE
" is displayed.
Press the "
ZONE2 ON/OFF
" and "
ZONE3 ON/OFF
" buttons.
Press the power button to switch the product to STANDBY.
140
Caution in
servicing
Electrical Mechanical Repair Information Updating
To Next Page
Loading...
