Denso BHT-604Q - Page 28

16
BHT-604Q
4. Slide the battery cover lock (1) in the direction
indicated by the arrow and remove the battery cover
(2).
5. Check the battery cartridge terminals and
indication on the BHT unit, and then insert the
cartridge in the direction indicated by the arrow.
Terminal
 Point  Do not use battery cartridges other
than those specified by DENSO
WAVE.
6. Insert the battery cover tab (1), and then close the
battery cover (2). tThe battery cover is now locked in
position.
Mishandling of the charger may result in charger overheating, smoke generation, blowout o
r
combustion. Please read the following items prior to use.
 Never disassemble or modify the battery cartridge.
 Never connect the battery cartridge (+) and (-) terminals with a metal object such as a piece o
f
wire.
 Never carry or store the battery cartridge together with metallic necklaces, hairpins and so on.
 Never expose the battery cartridge to fire or apply heat.
 Never use or leave the battery cartridge in the vicinity of high-temperature locations (60° C or
higher) such as a fire or stove.
 Never place the battery cartridge into or soak it in water or seawater.
 Never charge the battery cartridge in the vicinity of fire or under a scorching sun.
 Never hammer nails into the battery cartridge, hit it with a hammer, or trample on it.
 Never apply strong impact to or throw the battery cartridge.
 Never use significantly damaged or deformed battery cartridges.
 Never apply solder directly to the battery cartridge.
 If battery fluid leaked from the battery cartridge gets into the eyes or comes into contact with the
skin, wash thoroughly with clean water such as tap water without rubbing, and obtain medical
treatment immediately. Failure to do so will result in eye or skin injuries.