Barcode Handy Terminal
“3: ITF”: Minimum number of digits to be read for ITF
“4: STF”: Minimum number of digits to be read for STF
“5: CODABAR”: Minimum number of digits to be read for Codabar
Set minimum number of digits for the code to be read.
Press [
] to decrease the setting value and [ ] to increase the setting value.
ITF entry range: 2 - 20(Default: 4)
STF entry range: 1 - 20(Default: 3)
Codabar entry range: 3 - 20(Default: 4)
Setting a small number of digits increases the frequency of missing digits when reading, or incorrectly
reading depending on how barcodes are read, or the quality of barcodes. On the other hand, setting a
large number will decrease the possibility of such errors.
[5] Setting the communication environment
The communication environment settings following system initialization are follows.
Do not change these settings unless necessary.
Item Default
Interface port Optical (IrDA interface port)
Communication protocol Ymodem protocol
IrDA interface port
TRANSMIT SPEED Baud rate 115200 bps
PROTOCOL Protocol options SERIAL No.: ON (Adds serial numbers to data
blocks.
)
H. PARITY: ON (
Adds horizontal parity.)
LINKUP TIME: 30
seconds
FIELD SPACE: Ignore (
Trim)
71
To Next Page
Loading...
