Service EN
66 / 84 03/2020
Maintenance instructions
Cleaning
If needed, clean the external panels by using a dry cloth.
Maintenance program
Please consult us on the Tool Care program that includes production support and maintenance solutions.
Spare parts
Exploded views and spare parts lists are available at https://www.desouttertools.com/resource-centre.
The use of spare parts other than those originally supplied by the manufacturer may result in a drop in performance
or in increased maintenance and level of vibration and in the full cancellation of the manufacturer’s liability.
Read before maintenance
WARNING Connection Hazard
The tool can start unexpectedly and cause severe bodily injury.
► Prior to any maintenance task, disconnect the tool.
Maintenance should be performed by qualified personnel only.
Follow standard engineering practices and refer to exploded views for disassembling and reassembling the different
parts of the system.
Take into account the following instructions given in the exploded views.
Be cautious: when reassembling, tighten the right direction.
Left hand thread
Right hand thread
When reassembling:
Apply the recommended glue.
Tighten to the required torque.
Lubricate with the required grease or oil. Do not apply too much grease on gears or bearings; a thin coat shall be
sufficient.
Checking before putting back into service
Prior to putting the equipment back into service, check that its main settings have not been modified and that the
safety devices work properly.
Upgrading system and tool firmware
Checking the existing system firmware
Go to the start screen and tap this icon.
Tap Versions.
To Next Page
Loading...
Need help?
General
