Troubleshooting EN
68 / 84 03/2020
Troubleshooting
What if the tightening unit is not active
See above that Tightening unit - 53 is not active.
The tool can be paired but it will not run.
Go to the menu Feature management and rebalance the required UVs to the RIM.
Plug an Ethernet cable to any Ethernet port of CONNECT and to a computer.
Launch CVI CONFIG.
Select the relevant CONNECT.
Click Feature management.
Click this icon to update CVI CONFIG.
Go to the pane Current configuration on the top right and select the feature to activate.
Click this icon.
Click this icon to update the product.
Go to CONNECT and tap its screen to wake it up.
Tap this button on the front panel to display the start screen.
To Next Page
Loading...
Need help?
General
