Part Number
Issue
Date
Page
6159938880
13
01/2018
76 / 249
01/2018 76 (249)
Select the transducer and click Valid to confirm.
In the Tigh. counter screen:
the values of Tigh. Counter, Change screw cnt, Lead screw cnt values can be reset:
In order to reset the number of tightenings performed, select this
item of the list, press Enter, then press Valid
NOTE: It is possible to reset this parameter also when
the Delta on measurement when a Tool check: Pulse
Tool Preload Pset is selected. Press Both Left Arrow
and Right Arrow buttons to do this
NOTE: Reset this counter after greasing DLT screw
In order to reset the value of the number of tightenings
performed before the Change screw message is shown, select
this item of the list, press Enter then press Valid
NOTE: Reset this counter after replacing DLT screw
In order to reset the value of the number of tightenings
performed before the Change lead screw message is shown,
select this item of the list, press Enter then press Valid
NOTE: Reset this counter after replacing DLT lead
screw
To Next Page
