0065-0647-OM Rev E 7550 OWNER’S MANUAL
BLUETOOTH LOW ENERGY (BLE), CONT.
Enable Bluetooth (BLE) Networking, Cont.
IMPORTANT! If an attempt is made to turn Bluetooth (BLE) off when a device is
connected to the scale, the display will show the error message Error - BLE Off.
SETTINGS PAGE 7
Error – BLE Off
Wi-Fi: On
SSID: Dynex617
<<< Exit >>>
This message will be shown until <<< or >>> are pressed to change to a different settings
page, Exit is pressed to return to the Weight screen, or the error message Error - BLE Off is
touched, and then CANCEL is selected on the Bluetooth selection screen.
Note that at this time, Bluetooth (BLE) is still on, only the message has been cleared.
To turn Bluetooth (BLE) off, the device must be disconnected from the scale or the scale must
be turned “Off” and back “On”.
Bluetooth Pairing
To pair a Bluetooth-capable device with the scale, select the name of the scale from the list of
available connections: Icon Scale XX:XX:XX:XX:XX:XX. Note that the X’s represents the MAC
address of the BLE wireless transmitter in the scale’s weight indicator.
NOTE: If there are multiple 7550 scales nearby, perform the steps below to proceed to the
Settings Overview 2 page to view the scale’s Bluetooth Advertisement name (BLE Adv:).
BLE Adv: Icon Scale XX:XX:XX:XX:XX:XX
1. With the scale turned on and the Weight screen displayed, press the Menu key.
2. The display will change to show the Settings Overview 1 screen.
3. Press >>> to advance to the Settings Overview 2 screen.
4. The scale’s Bluetooth setting and Bluetooth Advertisement name will be shown.
5. Press Exit to exit Settings Overview 2 and return to the Weight screen.
When a stable reading is achieved, and if the scale is paired with a Bluetooth-capable device,
the reading will transmit when the device sends a request to receive data.
To Next Page
Loading...
Need help?
General
