RACK DIMENSIONS
Frame Width ‘W’ Frame widths are expressed by their nominal dimension, i.e. either 300,
400, 450, 500, 600, 800 or 1000mm.
Rack Width ‘W+’ The actual rack dimensions are slightly greater than the frame dimensions:
Single entry racks = nominal frame dimension + 6mm.
Double entry racks = nominal combined frame dimension + 12mm.
For racks with back bracing a further 4mm must be added for single racks
and 3mm for double racks.
Bay Length ‘L’ The bay length is the actual ‘centre to centre’ dimension between the
uprights.
Overall Rack Length The overall length of rack equals the total of the bay centres + 50mm.
Shelf Height Adjustment is on a 25mm increment, within the following limits.
Adjustment Short span bays, shelf pitches up to 800mm.
Medium span bays, shelf pitches up to 1500mm.
Shelf Heights To save confusion over baseplate thickness and differing amounts of
levelling due to uneven floors, all shelf heights are expressed from the top
of the baseplate.
This means shelves will have heights ending with 00, 25, 50, or 75mm
All dimensions within this manual are in millimetres (mm), unless stated otherwise.
Issue: June 2005 Section A – Product Introduction Page A.3
To Next Page
Loading...