Maintenance Manual LS8
Issued: September 2011 TN8020
Copyright DG Flugzeugbau GmbH - any copy or publishing prohibited
Manual valid with the up-to-date cover page only
8-3
8.3 Permanent installation of equipment in baggage compartment
Equipment may be permanently installed:
a) Attached to landing gear box >5< (not directly on the baggage
compartment floor >4<!) using threaded spacers >1<, three of which are
required per unit. Baggage compartment cover >4< has to be cut to insert
spacers, see drawing.
1 - Spacer, diameter 15 mm <0.6 in>,
For 4’’-wheel:
Part No. 4R7-8d,
length 23mm <0.906 in>.
For 5’’-wheel:
Part No. 4R7-96
length 45 mm <1.772 in>.
2 - Washer B6.4 DIN9021-St
outer diameter 18 mm <0.71 in>
3 - Bolt 6 mm thread*10 mm
DIN 85-A2, corrosion resistant
4 - Baggage compartment cover
5 - Landing gear box
b) Attached to cover >2< behind spar connection and as close as possible to
stiffening corrugation, approved for ELT and barograph only.
See drawing.
1 - Flange of unit
2 - Rear baggage compartment cover
3 - Washer B5.3 DIN9021-St
outer diameter 15 mm <0.59 in>
4 - Bolt 5 mm thread, length depending
on flange thickness,
5 - Self locking nut, 5 mm thread, width
over flats 8 mm, M5 DIN985-8
To Next Page
Loading...
