SM-200 TE Grinding and Honing Machine 59
Servicing and Maintenance
10
10. Servicing and Maintenance
10.1 Cleaning the SM-200 TE grinding and honing
machine
Clean the SM-200 TE grinding and honing machine after each use.
The grinding sludge is difficult to remove if it dries out.
We recommend lightly lubricating the machine with acid-free oil
after cleaning.
1 Remove the belt guards of the wet grinding belt.
2 Remove the polishing station cover.
3 Remove abrasion residues and grinding dust from the
WARNING
Risk of injuries due to unauthorised or thoughtless switching
on or wrong spare parts
• Always pull out the mains plug before carrying out any main-
tenance or repair work on the belt grinding machine.
• Use exclusively original spare parts from Friedr. Dick GmbH &
Co. KG.
WARNING
Risk of injuries due to improper repair work
• Any repair work on electric components may only be carried
out by qualified electricians.
NOTE
After finishing all repairs and servicing work, check that all disman-
tled parts have been completely and correctly installed, especially
the covers.
Perform a test run lasting 1 minute after changing the grinding belt,
lamellar buffing wheel or grinding wheel and working on the ribbed
or V-belt.
Switch off the machine in case of unusual behaviour and remedy
the cause of the problem.
To Next Page
Loading...