SM-200 TE Grinding and Honing Machine 61
Servicing and Maintenance
10
3 Press the I (ON) button on the main On/Off switch.
4 Set the On/Off switch for the abrasives and the On/Off switch
for the cooling water to position I (ON).
5 Pivot the dressing tool over the grinding wheel. Adjust the
knurled screw so that the dressing diamond touches the disc.
6 Move the dressing tool over the grinding wheel by hand.
Slightly adjust the knurled screw with the other hand with
every pivoting action.
7 Continue this dressing process until the grinding wheel is
clean and smooth.
8 Round the upper edge of the grinding wheel after the dressing
process. Use a dressing stone (accessory) to do this.
10.3 Changing the grinding wheel
Replace a worn or damaged grinding wheel immediately.
NOTE
• Never dry dress the grinding wheel.
Figure 10.5 – Changing the grinding wheel
[1] Grinding wheel
[2] Hexagon socket screw
[3] Clamping flange
To Next Page