Digi DS-470 - Transmit Set-Point Data; Transmit Set-Point Data From External Device

19
6.2. Transmit Set-Point Data
6.0.1. Transmit Set-Point Data From External Device
If Set-point data from an external device spec(spec 53 bit 2) is enabled and when
MAX key is pressed without entering numeric data I Operation mode, the scale would
send ENQ data and the external device would send the set-point data back.
TEXT COMMAND
CR The end of data 0DH Termination code
LF The end of text 0AH
0 –9 Numeric data (30H – 39H)
Period Period (2EH)
Data
Comma Comma (2CH)
F Set-point 1 (46H) Header code
H Set-point 2 (48H)
DATA FORMAT:
Header Set-point 1 CR Header Set-point 2 CR LF
1 5 1 1 5 1 1
All manuals and user guides at all-guides.com