Digi XBee3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
9
AT commands
Special commands 158
AC (Apply Changes) 158
FR (Force Reset) 158
RE (Restore Defaults) 158
WR (Write) 158
Cellular commands 160
PH (Phone Number) 160
S# (ICCID) 160
IM (IMEI) 160
MN (Operator) 160
MV (Modem Firmware Version) 160
DB (Cellular Signal Strength) 161
AN (Access Point Name) 161
CP (Carrier Profile) 161
BM (Bandmask) (LTE-M) 162
BN (Bandmask) (NB-IoT) 162
AM (Airplane Mode) 163
N# (Preferred Network Technology) 163
Network commands 165
IP (IP Protocol) 165
TL (SSL/TLS Protocol Version) 165
$0 (SSL/TLS Profile 0) 166
$1 (SSL/TLS Profile 1) 166
$2 (SSL/TLS Profile 2) 166
TM (IP Client Connection Timeout) 167
TS (IP Server Connection Timeout) 167
DO (Device Options) 167
DT (Cellular Network Time) 168
Addressing commands 169
SH (Serial Number High) 169
SL (Serial Number Low) 169
MY (Module IP Address) 169
P# (Destination Phone Number) 169
N1 (DNS Address) 170
N2 (DNS Address) 170
DL (Destination Address) 170
OD (Operating Destination Address) 170
DE (Destination port) 171
C0 (Source Port) 171
LA (Lookup IP Address of FQDN) 171
Serial interfacing commands 172
BD (Baud Rate) 172
NB (Parity) 172
SB (Stop Bits) 173
RO (Packetization Timeout) 173
TD (Text Delimiter) 173
FT (Flow Control Threshold) 173
AP (API Enable) 174
I/O settings commands 175
D0 (DIO0/AD0) 175
D1 (DIO1/AD1) 175
D2 (DIO2/AD2) 176
D3 (DIO3/AD3) 176
To Next Page
Loading...
Need help?
General
