DigiDesign 3 User Manual

003 & 003 Rack Getting Started Guide86
To toggle a send between pre- and post-fader
operation:
1 Press the Send switch to put 003 in Send View.
2 Press the Channel Select switch under a send
name to toggle its pre- and post-fader setting.
Insert View Workflows
When the Insert switch is enabled (lit), 003 is in
Insert View. In this view, the LCD shows the
names of currently-assigned inserts (hardware
inserts or plug-ins) across all channel strips for a
given insert position (Inserts A–E in Pro Tools).
If a hardware insert or plug-in is selected in
Pro Tools, its name flashes in the LCD.
In this view, you can display inserts, plug-in
controls, bypass plug-ins, and assign inserts in
Assign mode.
Working with Inserts
To display the inserts on an Insert position (A– E):
1 Press the Insert switch (Console View section)
to put 003 in Insert View.
2 Press the corresponding Insert/Send Position
switch A–E.
The names of all inserts on that track are dis-
played in the LCD. (While the names of hard-
ware I/O inserts are displayed, they have no ed-
itable parameters, so the Channel Select
switches and the rotary encoders have no effect
on them.)
To display the controls for a plug-in:
1 Press the Insert switch (Console View section)
to put 003 in Insert View.
2 Press the corresponding Insert/Send Position
switch A–E.
3 Press the Channel Select switch under a
plug-in name.
003 goes into Channel View and displays the
plug-in’s controls across all channel strips. Con-
trols are assigned to the rotary encoders.
Switched controls (such as Master Bypass or
Phase Invert) are controlled by Channel Select
switches.
4 To display additional pages of plug-in controls
(if any), press the Left and Right Page switches.
To bypass a plug-in:
1 Press the Insert switch (Console View section)
to put 003 in Insert View.
2 Hold Command/Ctrl and press the Channel
Select switch under the plug-in name.
The LCD screen displays the name of bypassed
plug-ins in all capital letters.
For information on assigning inserts in As-
sign mode, see “Assigning Pro Tools Paths
(Input, Output, Sends, Inserts)” on page 92.
The Left or Right Page switch flashes when
an additional page is available.

DigiDesign 3 Specifications

General

Brand	DigiDesign
Model	3
Category	Recording Equipment
Language	English