DigiDesign D-Control User Manual

D-Control Guide76
To change parameter mapping in a plug-in map:
1 Make sure the LrnTch (Learn Touch) preference (in the Op-
eration Soft Keys) is set to On.
2 Open the plug-in whose mapping you want to change.
3 Choose the map you want to change from the Map Preset
pop-up menu.
4 Put the plug-in into Learn mode. The plug-in map is focused
on the control surface.
5 On the control surface, do one of the following:
• For an EQ or Dynamics plug-in, make sure a plug-in of
the same type is displayed in the EQ or Dynamics section
of the control surface.
– or –
• For all other plug-in types, display a different instance of
the same plug-in type in a second location (for example,
on a channel strip in Normal mode, or in another bank of
Custom Faders).
6 Touch the encoder or press the switch for the parameter you
want to map. The encoder’s auto LED or the switch’s Mute
LED lights.
7 Locate the encoder where you want to change the mapping,
and if necessary, press the encoder Select switch to toggle be-
tween the two available views on the control.
8 Touch the encoder or press the B/M/P switch to map the pa-
rameter.
9 Take the plug-in out of Learn mode.
To remove parameter mapping from a plug-in map:
1 Make sure the LrnTch (Learn Touch) preference (in the Op-
eration Soft Keys) is set to On.
2 Open the plug-in whose mapping you want to change.
3 Choose the map you want to change from the Map Preset
pop-up menu.
4 Put the plug-in into Learn mode. The plug-in map is focused
on the control surface.
5 Locate the encoder where you want to change the mapping,
and if necessary, press the encoder Select switch to toggle be-
tween the two available views on the control.
6 Do one of following for each parameter mapping you want
to remove:
• If the Parameter menu shows No Control, touch the en-
coder or press the B/M/P switch to remove the parameter
mapping.
– or –
• If the Parameter menu shows the name of a preset, hold
Control (Windows) or Command (Mac) and press the
B/M/P switch to remove the parameter mapping.
7 Take the plug-in out of Learn mode.
Changing Plug-in Map Presets
You can select the next or previous plug-in map for a plug-in
directly from D-Control.
To enable the next or previous plug-in map from a channel strip:
1 Focus the plug-in in the channel strip so its controls are vis-
ible on the channel strip encoders.
2 Hold Start (Windows) or Control (Mac) and press the Page
Up (Next) or Page Down (Previous) switch in that channel
strip’s Channel Strip Mode controls. The name of the plug-in
map preset is shown momentarily in the bottom encoder dis-
play.
To enable the next or previous plug-in map from the Custom
Faders:
1 Focus the plug-in in the Custom Faders section.
2 Hold Start (Windows) or Control (Mac) and press the Page
Up (Next) or Page Down (Previous) switch in a Custom Fader
channel. The name of the plug-in map preset is shown mo-
mentarily in the Custom Fader channel displays.
To select the next or previous plug-in map on multiple
channels, use the Do To All and Do To Selected switches
on D-Control.

DigiDesign D-Control Specifications

General

Brand	DigiDesign
Model	D-Control
Category	Music Mixer
Language	English