Digisol DG-BG4100NU - Snmp

DG-BG4100NU User Manual
94
SNMP
This page is used to configure the SNMP protocol. Here you may change the setting f or
sy stem description, trap ip address, community name, etc.
The following table describes the parameters and buttons of this page:
Field
Description
Enable SNMP
Select it to enable SNMP function. You need to enable SNMP
and then y ou can configure the parameters of this page.
System
Description
System description of the DSL device.
System Contact
Contact person and/or contact inf ormation for the DSL device.
System Name
An administratively assigned name for the DSL device.
System Location
The physical location of the DSL dev ice.