DG-BG4300NU User
Manual
101
4.6.1.3 RIP
Click RIP in the left pane, the page shown in the following figure appears. If you are using
this device as a RIP-enabled router to communicate with others using Routing Information
Protocol (RIP), enable RIP. This page is used to select the interfaces on your devices that
use RIP, and the version of the protocol used.
The following table describes the parameters and buttons of this page:
Field Description
RIP Select Enable, the router communicates with other
RIP-enabled devices.
Apply Click it to save the settings of this page.
Interface Choose the router interface that uses RIP.
Receive Version Choose the interface version that receives RIP messages.
You can choose RIP1, RIP2, or Both.
•
Choose RIP1 indicates the router receives RIP v1
messages.
•
Choose RIP2 indicates the router receives RIP v2
messages.
•
Choose Both indicates the router receives RIP v1 and
RIP v2 messages.
Send Version
The working mode for sending RIP messages. You can
To Next Page
Loading...
Need help?
General
