DG-BG4300NU User
Manual
47
The following table describes the parameters of this page:
Field Description
IP Address
Enter the IP address of LAN interface. It is
recommended to use an address from a block that is
reserved for private use. This address block for
example is 192.168.1.1 - 192.168.1.254.
Subnet Mask
Enter the subnet mask of LAN interface. The range of
subnet mask is from 255.255.0.0 - 255.255.255.254.
Secondary IP
Select it to enable the secondary LAN IP address. The
two LAN IP addresses must be in different networks
IGMP Snooping
When IGMP snooping is enabled, only hosts that
belong to the group receive the multicast packets. If a
host is deleted from the group, the host cannot receive
the multicast packets any more.
LAN Port
You can choose the LAN interface you want to
configure.
Link Speed /
Duplex Mode
You can select the following modes from the
drop-downlist:100Mbps/FullDuplex,100Mbps/Half
Duplex,10Mbps/FullDuplex,10Mbps/HalfDuplex,Auto
Negotiation.
MAC Address
Control
It is the access control based on MAC address. Select
it, and the host whose MAC address is listed in the
Current Allowed MAC Address table can access the
router.
Add
Enter MAC address and then click it to add a new MAC
address.
Current allowed
MAC address table
All the allowed MAC addresses added will be listed
here.
To Next Page
Loading...
Need help?
General
