DG-PS1010U User Manual
49
5. Network Print Monitor
Preparation
The print server supports TCP/IP, IPX/SPX and NetBEUI protocols under Windows computer.
Please make sure that the following steps have been completed before proceeding with
installation under Windows 95/98/ME/NT4/2000/XP 32bit edition/server 2003 32bit edition.
Select A Desired Protocol
TCP/IP
The TCP/IP Protocol must be installed. For further information, please read “TCP/IP Protocol
Installation” section in this chapter.
Note: If TCP/IP protocol is chosen, please refer to “Assigning an IP Address to the print server”
section later in this chapter.
IPX/SPX
The IPX/SPX-compatible Protocol must be installed. For further information, please read
“IPX/SPX-compatible Protocol Installation” section in this chapter.
NetBEUI
The NetBEUI protocol must be installed. For further information, please read “NetBEUI Protocol
Installation” section in this chapter. The Windows XP/2003/Vista/7 does not support the NetBEUI
printing.
TCP/IP Protocol Installation
1. Click Start, point to Settings and select Control Panel.
2. Double click the Network icon.
3. If the TCP/IP Protocol is not already installed, click Add.
To Next Page
Loading...