DG-PS1010U User Manual
48
SNMP Community:
The print server supports up to two community names. The default community
name is public (case-sensitive), with Read Only access right in default.
Support HP WebJetAdmin:
This option allows user determine to disable/enable the Support HP WebJetAdmin.
SNMP Traps:
Enable the function of sending SNMP Authentication Failure trap message to the
network administrator, if the community name within a SNMP request is not correct.
SMB Setup
The print server supports the SMB (Server Message Block) protocol, user can send the print jobs
through Network Neighborhood without installing print server’s driver.
1. Click Setup, it appears the sub-menu.
2. Click SMB, it as shown in the following picture.
Fig 37
3. Workgroup Name:
This option allows you to assign a workgroup name to print server on the Network
Neighborhood. Windows uses it to identify the print server on the Network.
4. Shared Name:
This option allows you to assign a name to print server’s port.
To Next Page
Loading...
Need help?
General