DG-PS1010U User Manual
23
Gateway:
This option shows the print server’s current gateway address which maybe obtained from
the DHCP server or manually specified. This option also allows you to manually specify the
IP address of the gateway to the print server, if DHCP option is disabled. This value is
optional
Upgrade
Upgrade allows the user to upgrade the firmware of print server device. Please perform the below
steps for upgrade:
1. Click Upgrade button ＜
＞, we will see the below shown wizard.
Fig 19
2. Select General Upgrade. Ensure that the upgrade file is located in the same directory as
PSAdmin.
Reset
1. Click Reset button ＜ ＞.
2. Reset allows the user to reset the print server in order to establish a new connection or for
new settings to take effect.
Refresh
1. Click Refresh button ＜
＞.
2. Refresh searches the network for all attached print server(s).
To Next Page
Loading...
Need help?
General