EasyManuals Logo

Digisol DG-PS1010U User Manual

Digisol DG-PS1010U
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
DG-PS1010U User Manual
77
A printer driver is missing or is incompatible with that printer. Using a print driver that is not
specific for the printer can cause printing errors. Install the proper printer driver. If these printer
drivers are not available to you, please contact your printer manufacturer.
Question C
The upgrading process indication bar stops and does not seem to proceed again while upgrading
the print server.
Possible Explanation
There might be a network problem. This causes the upgrading procedure to fail.
Solutions
1. Check the network cabling, especially from the workstation running the PSAdmin to the
print server unit.
2. Run the PSAdmin and upgrade the print server again.
Question D
The Status LED light keeps blinking after POST.
Possible explanation and solution
The last upgrade process was not completed. The print server must be upgraded again by using
the PSAdmin. Please see Chapter 3 for details.
Question E
The PSAdmin reports “Create Print server Error”, “Create Printer Error”, or “Create Print Queue
Error” while using Auto Setup.
Possible Explanation
The print server name, the printer name, or the print queue name you specified in the Auto Setup
dialogue box contains a space.
Solution
Check to see if there is a space in the print server name, the printer name, or the queue name.
Type in a new name without a space between two characters or replace a space by a dash (-) or
an underscore (_).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digisol DG-PS1010U and is the answer not in the manual?

Digisol DG-PS1010U Specifications

General IconGeneral
BrandDigisol
ModelDG-PS1010U
CategoryPrint Server
LanguageEnglish