Installing the Batteries
The camera is powered by two AA batteries (not included).
To install the camera batteries:
1. Slide the battery compartment door open. To do this, put your
finger in the indention on the compartment door and slide it down.
The door will pop open.
2. Insert the batteries using the battery polarity symbols (+/-) as a guide.
These symbols are located on the inside of the battery compartment door.
3. Close the battery compartment door. To do this, press the battery door
down and slide it back into place.
4. Turn the camera on by pressing the Power button and wait a moment.
You will see the Power LED Light flash when the camera is turning on.
To turn the camera off, press the Power button again.
Note: If the camera is not used for 60 seconds, it will automatically shut
down. To restart the camera, press the Power button and wait a moment.
1
2
Camera Basics
Viewfinder Flash Strobe
Camera Lens
Power Button
Snapshot Button
Power LED
2 AA Batteries
(Not Included)
Polarity Symbols
Battery Compartment
Door
Camera Components
Power Button- Turn the camera on by pressing the Power button
and wait a moment.
Power LED- Illuminates when the camera is performing
various functions.
Snapshot Button- Use the Snapshot button to take pictures.
Flash Strobe- Use the Flash Strobe when you are indoors
or in low-light situations
Viewnder- Use the Viewfinder to frame your pictures.
Camera Lens- Make sure to keep the camera lens clean and clear
when taking pictures. Be sure not to block the lens with
your finger!
To Next Page
Loading...
Need help?
General
