The SPLIT1 Output mode routes guitar signal to the 1/4” outputs while the mic,line input sources,
drums,and audio playback from the onboard 8-track recorder and the computer are routed out the XLR
outputs.
SPLIT2 is the same as SPLIT1 but the guitar signal with Speaker Compensation is also routed
out the XLR outputs.
SPLIT1 - Stereo guitar processing is routed to the 1/4” outputs. Audio playback from the computer, mic,
and line sources are routed to the XLR outputs. Speaker Compensation can be individually
turned on and off either the 1/4” or XLR outputs using the Speaker Compensation switch
located next to each output pair on the rear panel.
SPLIT2 - Stereo guitar processing is routed to the 1/4” outputs without Speaker Compensation. Stereo
guitar processing,audio playback from the computer, mic, and line sources are routed to the
XLR outputs with Speaker Compensation. Speaker Compensation can be individually turned
on and off either the 1/4” or XLR outputs using the Speaker Compensation switch located
next to each output pair on the rear panel.
To Next Page
Loading...
Need help?
General
