Loop Level4.
Controls the output level of the loop phrase.
Rhythm Level5.
Controls the level of the Rhythm guide track.
Card Memory LED6.
This red LED is lit when you are selecting loop memories on the
optional SD/SDHC memory card. When this LED is off, loops are being
selected from the JamMan
®
Delay’s internal memory.
Single LED7.
This yellow LED indicates the current phrase memory is set to playback
only once when play is initiated. Single phrases can be converted to
Loop phrases and vice versa.
Loop LED 8.
This green LED indicates the current phrase memory is set to playback
continuously as a loop when play is initiated. Loop is the default setting
when a phrase is recorded; any audio that is recorded will be recorded
as a loop phrase. Loop phrases can be converted to Single phrases and
vice versa.
Looper Status LEDs9.
These three LEDS indicate the looping status: Record, Playback, and
Overdub. Each will light individually during the process of recording,
playing back, and overdubbing a loop phrase.
Display10.
The main purpose for the display is to show the currently selected
13
Guided Tour - Front Panel
To Next Page
Loading...
Need help?
General
