14
loop memory location. It also shows information during store/copy
procedures, during Time Signature and Rhythm Type setup, file deletion,
and card formatting procedures.
Loop Select buttons11.
The Loop Select buttons are used for selecting different loop memories
and making selections when in other modes (such as Time Signature,
Rhythm Type, and Stop Mode).
Rhythm LED12.
This red LED will light when selecting the Rhythm guide track to record
and play with. You can hear the changes as you make them if the Rhythm
Level knob is turned up.
Time Signature LED13.
This red LED will light when selecting the Time Signature for a new loop
memory location. Note that Time Signature can only be changed for a
memory location that has no phrase recorded in it. You can select from
2 to 15 beats per measure. This means if you want to record in 5/4 time,
select 5 in the display. To record in 7/8 time, select 7, and so forth.
Stop Mode LED14.
This red LED will light when selecting the Stop Mode for the current
loop. Press the Setup button until this LED lights and then use the Loop
Select Up/Down buttons to change between one of the three Stop
Modes, Stop, Finish, and Fade.
Guided Tour - Front Panel
To Next Page
Loading...
Need help?
General
