EasyManua.ls Logo

Digitimer DS5 - Environmental, Maintenance, and Modification

Digitimer DS5
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DS5 Isolated Bipolar Constant Current Stimulator DS5 Operator's Manual 5.0
EN 60601 (IEC 60601):1990 Classifications
This equipment is CLASS I with TYPE BF Applied Parts.
This equipment is NOT sealed against any ingress of water and is therefore IPX0.
This equipment is NOT intended to be used sterile. If it is necessary to remove contamination from
the surface of the equipment, an alcohol moistened cloth may be used. Sterilisation of any
electrodes should be performed according to the recommendations from their manufacturer.
This equipment must NOT be used in the presence of flammable anaesthetic gases.
This equipment is rated for CONTINUOUS operation.
Environmental
This unit does not produce any waste. As with all electronic devices, at the end of its life it should be
disposed of by a registered waste contractor who is made aware of its nature.
Cleaning, Maintenance & Servicing
If the stimulator requires cleaning, it should be unplugged from the mains power supply and wiped with a
damp cloth.
This equipment does not require any regular maintenance but Digitimer recommends that the DS5 is
returned to the factory for inspection and re-testing every 2 years. Please contact us for a reference
number and instructions before despatching the unit.
For on-site testing, a guide to recurrent testing procedures is given in Chapter 4, Annex 1.
Before each use - The case and all leads should be inspected for any damage. The equipment (or the lead)
should be sent for repair if any damage is found.
For all servicing requirements please contact Digitimer, who can advice on best course of action. Digitimer
also offer to supply a service manual (chargeable) to fully qualified, and certified, service repair centres.
Modification Status
The green and white serial number label affixed to the rear of each DS5 contains the unique serial number
of that unit. This serial number should be quoted whenever technical support is requested from Digitimer or
one of our representatives.
The DS5 stimulator has serial numbers of the following format: DS5-72-2006. The last 4 digits of the serial
number denote the year of manufacture.
Digitimer Ltd. 11 of 52 Copyright © 2009

Table of Contents