Digitus DA-81003 - Reading Interval Time; Same Code Reading Delay

11
level above 50ms and then cancel, and the reading will be suspended; in the paused reading
state, also maintain the trigger level above 50ms and then cancel to continue reading.
Continuous mode
3.5.1 Reading interval time
It refers to the interval time required for the next reading after the reading is successful.
During this interval, no acquisition and reading are performed. Read the following setting
codes to set the reading interval. The setting range is 0ms ～ 25500ms, and the default
duration is 1000ms.
No interval
200 ms
500 ms **1000 ms
3000 ms 5000 ms
3.5.2 Same code reading delay
In order to avoid the same bar code being read multiple times in continuous mode, you can
request the read module to delay the set time in this mode before allowing the same bar
code to be read. The same code reading delay refers to the refusal to read the same bar
code within the set time after reading a bar code. Only after the duration has expired can it
be read and output. By default, the same code reading delay is turned off.