Digitus DA-81003 - Operating Setting; Use of the Setting Code; Factory Default Reset

4
1. Operating Setting
The factory default settings of DA-81003 can meet the needs of users for direct use in most
cases. You can also set the parameters through the setting code according to actual needs.
1.1 Use of the setting code
Read the "Enable Setting Code" to configure the function of the reading module (setting
code function). After the function is turned on, you can modify the parameters of the reader
module by reading one or more setting codes. After reading the "Close Setting Code", the
scanning module will exit the setting state.
**Enable Setting Code
Close Setting Code
Set the code content output enable and disable.
Output setting code content
**Do not output the content of
the setting code
Note: The options marked with (**) in the setting code indicate the default functions or
parameters.
1.2 Factory Default Reset
After reading these two setting code in order, the current parameter setting will be lost, and
the factory default value will be restored. The factory default parameters and functions can
be found in Appendix C.
Restore Factory Default
Wireless Restore Factory Settings
Note: Please use the "Restore Factory Default" function with caution.