Digitus DA-81003 - End Character Setting; Data Section

26
6.4 End Character Setting
By default, the scanner is sending a 'carriage return' after scanning a code (the same as
pressing the 'enter' key).
CR/ENTER (default) CR+LF
Tab Disable suffix
To add Carriage Return, please read code " Add Carriage Return”; to remove Carriage
Return, please read code " disable suffix".
6.5 Data section
6.5.1 Data segment interception
This function is used in scenarios where the user needs to output part of the decoded
information.
The decoding information Data consists of 3 parts:
(Start) (Center) (End)
The user can select part of the information to be output by reading the following setting
codes.
**Transfer the entire data Only transfer the Start segment