8
3.2 Trigger Mode
The trigger condition can be selected in manual mode. The default trigger condition is level
trigger, or edge trigger can also be selected.
• Edge triggering means that the level pulse of the trigger signal is detected, that is, the
reading starts, and the reading ends when the reading is successful, or the single
reading time condition is reached.
• The level trigger condition means that the level of the trigger signal needs to be
maintained from the beginning of the reading to the end of the reading. When the
trigger level is cancelled, the reading is successful or the reading exceeds the single
reading time, the reading ends.
Edge triggering
** level trigger condition
3.2.1. Single reading time
The duration of a single reading refers to the longest time allowed to maintain the scanning
and reading attempts after the reading is triggered and the reading is unsuccessful. When
this time is exceeded, the reading state will be exited. The range of single reading time is
100ms～25500ms. Read the following setting codes to set the duration of a single reading.
1000 ms
3000 ms
** 5000 ms
Infinite
To Next Page
Loading...
